Linksys RV082 Manuel d'utilisateur télécharger pdf (Page 51)

Chapter 6: Set Up and Configure the Router

VPN Tab - Gateway to Gateway

10/100 8-Port VPN Router

IP Only: If you select IP Only, only the specific IP Address that you enter will be able to access the tunnel. It’s the

IP Address of the remote VPN Router or device with which you wish to communicate. The remote VPN device can

be another VPN Router or a VPN Server. The IP Address will be the static, fixed IP only.

IP + Domain Name(FQDN) Authentication: If you select this type, enter the FQDN (Fully Qualified Domain Name)

and IP address of the VPN device at the other end of the tunnel. The FQDN is the host name and domain name for

a specific computer on the Internet, for example, vpn.myvpnserver.com. The IP and FQDN must be the same as

the Local Gateway of the remote VPN device, and the same IP and FQDN can be used only for one tunnel

connection.

IP + E-mail Addr.(USER FQDN) Authentication: If you select this type, enter the E-mail address and IP address of

the VPN device at the other end of the tunnel.

Dynamic IP + Domain Name(FQDN) Authentication: If you select this type, the Remote Security Gateway will be a

dynamic IP, so you don’t need to enter the IP address. When the Remote Security Gateway requests to create a

tunnel with the RV082, the RV082 will work as a responder. If you select this type, just enter the Domain Name for

Authentication, and the Domain Name must be the same as the Local Gateway of the remote VPN device. The

same Domain Name can be used only for one tunnel connection, and users can’t use the same Domain Name to

create a new tunnel connection.

Dynamic IP + E-mail Addr. (USER FQDN) Authentication: If you select this type, the Remote Security Gateway will

be a dynamic IP, so you don’t need to enter the IP address. When the Remote Security Gateway requests to create

a tunnel with the RV082, the RV082 will work as a responder. If you select this type, just enter the E-mail address

for Authentication.

Remote Security Group Type: Select the Remote Security Group that is behind the above Remote Gateway Type

you chose that can use this VPN tunnel. Remote Security Group Type may be a single IP address, a Subnet or an

IP range.

IP Address: If you select IP Address, only the remote computer with the specific IP Address that you enter will

be able to access the tunnel.

Subnet: If you select Subnet (which is the default), this will allow all computers on the remote subnet to

access the tunnel. Enter the remote IP Address and the Subnet Mask. The default Subnet Mask is

255.255.255.0.

IP Range: If you select IP Range, it will be a combination of Subnet and IP Address. You can specify a range of

IP Addresses within the Subnet which will have access to the tunnel.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 102 103

Pas de commentaire

Linksys RV082 Manuel d'utilisateur Page 51