Linksys RV082 Manuel d'utilisateur télécharger pdf (Page 68)

Chapter 6: Set Up and Configure the Router

Wizard Tab

10/100 8-Port VPN Router

Access Rule Setup

1. Click the Launch Now button to run the Access Rule Wizard to help you easily set up the Firewall security

policy for the Router.

2. The first screen to appear is Figure 6-64. This screen explains the Access Rules. Click Next to continue. Click

Exit if you want to exit the wizard.

3. The next screen to appear is shown in Figure 6-65. Select Allow or Deny for the action. Click Next to

continue. Click Previous if you want to return to the previous screen. Click Exit if you want to exit the wizard.

4. The next screen to appear is shown in Figure 6-66. Select the service from the drop-down menu that will be

allowed or denied from the Service menu. Click Next to continue. Click Previous if you want to return to the

previous screen. Click Exit if you want to exit the wizard.

5. The next screen to appear is Figure 6-67. Select the log from the drop-down menu, Log packet match this

rule or Not log. Click Next to continue. Click Previous if you want to return to the previous screen. Click Exit

if you want to exit the wizard.

6. The next screen to appear is shown in Figure 6-68. Select the Source from the Ethernet drop-down menu.

Then, select the users from the drop-down menu, Any, single, or Range. Click Next to continue. Click

Previous if you want to return to the previous screen. Click Exit if you want to exit the wizard.

7. The next screen to appear is Figure 6-69. Select the destination, either Any, Single, or Range, from the

drop-down menu. Click Next to continue. Click Previous if you want to return to the previous screen. Click

Exit if you want to exit the wizard.

8. The next screen to appear is shown in Figure 6-70. Select the scheduling for the rule, Always, if the Rule is

always in effect, or Scheduling, if you want to define a range for a specific time and day of the week. Click

Next to continue. Click Previous if you want to return to the previous screen. Click Exit if you want to exit the

wizard.

9. The final screen that appears is Figure 6-71. If you don’t need to make any changes click Save Settings.

Click Previous if you want to return to the previous screen. Click Exit if you want to exit the wizard. The

screen in Figure 6-72 will appear when the settings are correct.

Figure 6-64: Access Rules Policy

Figure 6-65: Select the Action

Figure 6-66: Select the Service

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 102 103

Pas de commentaire

Linksys RV082 Manuel d'utilisateur Page 68