Linksys SRW2016 Manuel d'utilisateur Page 117

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 123
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 116
107
Appendix F: Regulatory Information
WebView Switches
Safety Compliance
Warning: Fiber Optic Port Safety
When using a fiber optic port, never look at the transmit laser while it is powered on. Also,
never look directly at the fiber TX port and fiber cable ends when they are powered on.
Avertissment: Ports pour fibres optiques - sécurité sur le plan optique
Ne regardez jamais le laser tant qu'il est sous tension. Ne regardez jamais directement le
port TX (Transmission) à fibres optiques et les embouts de câbles à fibres optiques tant qu'ils sont sous tension.
Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit
Niemals ein Übertragungslaser betrachten, während dieses eingeschaltet ist. Niemals
direkt auf den Faser-TX-Anschluß und auf die Faserkabelenden schauen, während diese eingeschaltet sind.
Please read the following safety information carefully before installing the switch:
WARNING: Installation and removal of the unit must be carried out by qualified personnel only.
"The unit must be connected to an earthed (grounded) outlet to comply with international safety standards.
"Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection.
"The appliance coupler (the connector to the unit and not the wall plug) must have a configuration for mating with
an EN 60320/IEC 320 appliance inlet.
"The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by
disconnecting the power cord from the outlet.
"This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950. The conditions are
only maintained if the equipment to which it is connected also operates under SELV conditions.
France and Peru only
This unit cannot be powered from IT† supplies. If your supplies are of IT type, this unit must be powered by 230 V
(2P+T) via an isolation transformer ratio 1:1, with the secondary connection point labeled Neutral, connected
directly to earth (ground).
† Impédance à la terre
LASERGER
DER KLASSE I
ÄT
DISPOSITIF LASER
DE CLASSE I
CLASS I
LASER DEVICE
Vue de la page 116

Commentaires sur ces manuels

Pas de commentaire