Linksys WIRELESS-G WRT54GS Manuel d'utilisateur télécharger pdf (Page 37)

Chapter 5: Configuring the Wireless-G Broadband Router

The Security Tab - VPN Passthrough

Wireless-G Broadband Router with SpeedBooster

The Security Tab - VPN Passthrough

Use the settings on this tab to allow VPN tunnels using IPSec, PPTP, or L2TP protocols to pass through the

Router’s firewall.

IPSec Pass-through. Internet Protocol Security (IPSec) is a suite of protocols used to implement secure

exchange of packets at the IP layer. To allow IPSec tunnels to pass through the Router, click Enable. IPSec Pass-

Through is enabled by default.

PPTP Pass-through. Point-to-Point Tunneling Protocol (PPTP) allows the Point-to-Point Protocol (PPP) to be

tunneled through an IP network. To allow PPTP tunnels to pass through the Router, click Enable. PPTP Pass-

Through is enabled by default.

L2TP Pass-through. Layer 2 Tunneling Protocol is the method used to enable Point-to-Point sessions via the

Internet on the Layer 2 level. To allow L2TP tunnels to pass through the Router, click Enable. L2TP Pass-Through

is enabled by default.

Change these settings as described here and click the Save Settings button to apply your changes or Cancel

Changes to cancel your changes.

Figure 5-29: Security Tab - VPN Passthrough

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 88 89

Pas de commentaire

Linksys WIRELESS-G WRT54GS Manuel d'utilisateur Page 37