Linksys USB1000 Manuel d'utilisateur télécharger pdf (Page 11)

Chapter 3: Setup Utility for the Gigabit USB Adapter

Hardware Installation

Gigabit USB Adapter

3. The driver files will be copied onto your PC.

4. This screen will appear when the installation is complete. Click Finish to finish the installation.

Click the Exit tab to exit the Utility.

Hardware Installation

1. Connect the USB Connector of the Gigabit USB Adapter to the USB port of your computer. Slide the connector

out from it’s holder, unwind the cable, and connect the USB Connector to the USB port in your PC.

The Adapter will be automatically detected and installed by Windows. Your Windows operating system may

require you to restart your computer to complete the installation.

2. Connect an Ethernet cable to the Ethernet port on the Adapter, then connect the other end to the Ethernet port

on the switch or other networking device.

The setup is complete.

Figure 3-5: Setup Being Performed

Figure 3-6: Installation Complete

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Pas de commentaire

Linksys USB1000 Manuel d'utilisateur Page 11