Linksys WAPPOE Manuel d'utilisateur télécharger pdf (Page 10)

Chapter 2

Connection

Power Over Ethernet Adapter Kit

Power on a Device that Uses a Standard

Power Adapter

Use the Injector and Splitter to power up a device that uses a standard

power adapter. Follow these instructions:

Connect the Injector’s built-in Ethernet network cable to your router,

switch, or other network device.

Connect the Kit’s included Ethernet network cable to the Injector’s

Power & Data OUT port.

NOTE: If this cable is not long enough, then you can use your

own Ethernet network cable.

Then connect the other end to the Splitter’s Power & Data IN port.

Connect the Splitter’s built-in Ethernet network cable to the Ethernet

port of your remotely located access point or other network device.

Connect the Splitter’s Power cord to the Power port of your remotely

located access point or other network device.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

Linksys WAPPOE Manuel d'utilisateur Page 10